TonBERRY/micropython
3
0
Fork 0
Code Pull Requests Activity

all: Fix spelling mistakes based on codespell check.

Browse Source 
Signed-off-by: Damien George <damien@micropython.org>
This commit is contained in:
Damien George
2023-03-08 14:10:02 +11:00
parent e160fe7bc6
commit b1229efbd1
191 changed files with 282 additions and 282 deletions
Download Patch File Download Diff File Expand all files Collapse all files

8
docs/esp32/tutorial/intro.rst
View File

@@ -17,7 +17,7 @@ Requirements
The first thing you need is a board with an ESP32 chip. The MicroPython
software supports the ESP32 chip itself and any board should work. The main
characteristic of a board is how the GPIO pins are connected to the outside
world, and whether it includes a built-in USB-serial convertor to make the
world, and whether it includes a built-in USB-serial converter to make the
UART available to your PC.
Names of pins will be given in this tutorial using the chip names (eg GPIO2)
@@ -59,7 +59,7 @@ bootloader mode, and second you need to copy across the firmware. The exact
procedure for these steps is highly dependent on the particular board and you will
need to refer to its documentation for details.
Fortunately, most boards have a USB connector, a USB-serial convertor, and the DTR
Fortunately, most boards have a USB connector, a USB-serial converter, and the DTR
and RTS pins wired in a special way then deploying the firmware should be easy as
all steps can be done automatically. Boards that have such features
include the Adafruit Feather HUZZAH32, M5Stack, Wemos LOLIN32, and TinyPICO
@@ -104,7 +104,7 @@ Serial prompt
Once you have the firmware on the device you can access the REPL (Python prompt)
over UART0 (GPIO1=TX, GPIO3=RX), which might be connected to a USB-serial
convertor, depending on your board. The baudrate is 115200.
converter, depending on your board. The baudrate is 115200.
From here you can now follow the ESP8266 tutorial, because these two Espressif chips
are very similar when it comes to using MicroPython on them. The ESP8266 tutorial
@@ -124,7 +124,7 @@ after it, here are troubleshooting recommendations:
* The flashing instructions above use flashing speed of 460800 baud, which is
good compromise between speed and stability. However, depending on your
module/board, USB-UART convertor, cables, host OS, etc., the above baud
module/board, USB-UART converter, cables, host OS, etc., the above baud
rate may be too high and lead to errors. Try a more common 115200 baud
rate instead in such cases.