TonBERRY/micropython
3
0
Fork 0
Code Pull Requests Activity

all: Fix spelling mistakes based on codespell check.

Browse Source 
Signed-off-by: Damien George <damien@micropython.org>
This commit is contained in:
Damien George
2023-03-08 14:10:02 +11:00
parent e160fe7bc6
commit b1229efbd1
191 changed files with 282 additions and 282 deletions
Download Patch File Download Diff File Expand all files Collapse all files

10
docs/esp8266/tutorial/intro.rst
View File

@@ -18,7 +18,7 @@ The first thing you need is a board with an ESP8266 chip. The MicroPython
software supports the ESP8266 chip itself and any board should work. The main
characteristic of a board is how much flash it has, how the GPIO pins are
connected to the outside world, and whether it includes a built-in USB-serial
convertor to make the UART available to your PC.
converter to make the UART available to your PC.
The minimum requirement for flash size is 1Mbyte. There is also a special
build for boards with 512KB, but it is highly limited comparing to the
@@ -70,7 +70,7 @@ need to put your device in boot-loader mode, and second you need to copy across
the firmware. The exact procedure for these steps is highly dependent on the
particular board and you will need to refer to its documentation for details.
If you have a board that has a USB connector, a USB-serial convertor, and has
If you have a board that has a USB connector, a USB-serial converter, and has
the DTR and RTS pins wired in a special way then deploying the firmware should
be easy as all steps can be done automatically. Boards that have such features
include the Adafruit Feather HUZZAH and NodeMCU boards.
@@ -128,7 +128,7 @@ Serial prompt
Once you have the firmware on the device you can access the REPL (Python prompt)
over UART0 (GPIO1=TX, GPIO3=RX), which might be connected to a USB-serial
convertor, depending on your board. The baudrate is 115200. The next part of
converter, depending on your board. The baudrate is 115200. The next part of
the tutorial will discuss the prompt in more detail.
WiFi
@@ -137,7 +137,7 @@ WiFi
After a fresh install and boot the device configures itself as a WiFi access
point (AP) that you can connect to. The ESSID is of the form MicroPython-xxxxxx
where the x's are replaced with part of the MAC address of your device (so will
be the same everytime, and most likely different for all ESP8266 chips). The
be the same every time, and most likely different for all ESP8266 chips). The
password for the WiFi is micropythoN (note the upper-case N). Its IP address
will be 192.168.4.1 once you connect to its network. WiFi configuration will
be discussed in more detail later in the tutorial.
@@ -169,7 +169,7 @@ after it, here are troubleshooting recommendations:
* The flashing instructions above use flashing speed of 460800 baud, which is
good compromise between speed and stability. However, depending on your
module/board, USB-UART convertor, cables, host OS, etc., the above baud
module/board, USB-UART converter, cables, host OS, etc., the above baud
rate may be too high and lead to errors. Try a more common 115200 baud
rate instead in such cases.